Home ReviewsRefund
Home/Mazda/MX-5/Mazda MX-5 NB рестайлинг (2001-2005)/Repair manual/Restraints Control Systems/Seat Belt System: Removal & Installation
Contents Section: Restraints Control Systems All sections

Seat Belt System: Removal & Installation Mazda MX-5 NB рестайлинг

Restraints Control Systems 2 illustrations ~105 words

SEAT BELT REMOVAL/INSTALLATION

  1. Handling the front seat belt (pre-tensioner seat belt) improperly can accidentally deploy the pre-tensioner, which may seriously injure you. Read SERVICE WARNINGS before handling the front seat belt. (See «AIR BAG SAFETY PRECAUTIONS».)
CAUTIONThe ELR has a spring that will unwind if the retractor's cover is removed. The spring cannot be rewound by hand. If this occurs, the ELR will not work properly. Therefore, do not disassemble the retractor.

Scheme 1

Scheme 1
Scheme 1

Scheme 2

Scheme 2
Scheme 2
  1. Disconnect the negative battery cable.
  2. Remove the quarter trim. (See «QUARTER TRIM REMOVAL/INSTALLATION»(/mazda/mx-5/nb-2001-2005/remont/exteriorinterior-trim/#interior-trim) .)
  3. Remove in the order indicated in the table.
  4. Install in the reverse order of removal.
  1. Inspect the webbing for scars, tears, and wear.
  2. Inspect the fittings for deformation and damage. If a problem is found, replace the seat belt.

More articles — Seat Belt System