REMOVAL & INSTALLATION
| WARNING | To avoid injury from accidental air bag deployment, read and carefully follow all SERVICE PRECAUTIONS and DISABLING & ACTIVATING AIR BAG SYSTEM procedures in appropriate AIR BAG RESTRAINT SYSTEM article in ACCESSORIES/SAFETY EQUIPMENT section. |
Remove glove box. Disconnect electrical connectors. Loosen seal plate between blower assembly and evaporator unit. Remove blower assembly bolts and blower assembly. Disassemble blower assembly to remove blower motor and blower resistor. To install, reverse removal procedure.
Remove rear center console. Remove vent outlets from center panel. Remove center panel. Remove control panel screws, and pull control panel from center panel. Disconnect heater control cables. To install, reverse removal procedure.
Drain coolant. Disconnect heater hoses at engine compartment firewall. Remove grommets from holes (if equipped). Remove instrument panel. See REMOVAL & INSTALLATION in MANUAL A/C HEATER SYSTEMS article in the AIR CONDITIONING & HEAT section. Remove heater unit.
Disassemble heater unit to remove heater core. (Схема №1) To install, reverse removal procedure. Fill cooling system.
