Disconnect negative battery cable. Drain cooling system. Remove timing belt. See TIMING BELT . Remove idler pulleys for timing belt (if necessary). Remove No. 3 engine mount bracket located above water pump on cylinder block. Remove retaining bolts, water pump and "O" ring seal.
Installation
To install, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS . Fill and bleed cooling system. See COOLING SYSTEM BLEEDING .
- Disconnect negative battery cable. Raise and support vehicle. Drain engine oil. Remove lower engine covers. Remove exhaust pipe.
- Remove oil pan retaining bolts. Using screwdriver or seal cutter, remove oil pan from block. Remove oil strainer and gasket (if necessary).
- Install oil strainer and NEW gasket (if removed). Tighten retaining bolts to specification. See «TORQUE SPECIFICATIONS»(ref-123341-S20277020582001092100000) . Ensure sealing surfaces are clean. Apply bead of sealant onto inside of bolt holes and at center of oil pan sealing surface, between bolt holes. CAUTION: Before installing oil pan bolts, ensure oil pan bolts and cylinder block bolt holes are free of sealant. Cylinder block may crack if bolts are not cleaned before installation.
- Install oil pan. Install bolts, and tighten to specification. See «TORQUE SPECIFICATIONS»(ref-123341-S20277020582001092100000) . To install remaining components, reverse removal procedure. Fill crankcase with oil.