REMOVAL & INSTALLATION
Note. If equipped with audio anti-theft system, before disconnecting battery cable, obtain radio code number from customer and deactivate audio anti-theft system.
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. |
Remove door trim panel. Remove screws securing main switch to door trim panel. Pull out main switch and disconnect electrical connector. Remove main switch. To install, reverse removal procedure.
Remove door trim panel. Remove screw(s) securing sub-switch to door trim panel. Pull out sub-switch and disconnect electrical connector. Remove sub-switch. To install, reverse removal procedure.
Fully open window. Raise window until height of glass (measured at top rear edge) is as specified. See WINDOW HEIGHT SPECIFICATIONS . Disconnect negative battery cable. Remove door trim panel and water shield. Disconnect window motor electrical connector. Remove window regulator and motor as an assembly. Securely position regulator arms in full-up position (if possible) to relieve spring pressure. Remove window motor from regulator. To install, reverse removal procedure.