Interior Trim: Overview Mazda 5 I рестайлинг

Scheme 1

Scheme 2

Scheme 3

Scheme 4

Scheme 5

1. Remove the battery cover. (See «BATTERY REMOVAL/INSTALLATION [L3]».)
2. Disconnect the negative battery cable.
3. Remove the following parts: Front door (See «FRONT DOOR REMOVAL/INSTALLATION».) Sail garnish (See «SAIL GARNISH REMOVAL/INSTALLATION»(/mazda/5/i-2007-2010/remont/exteriorinterior-trim/#exterior-trim).) Front scuff plate inner (See «FRONT SCUFF PLATE REMOVAL/INSTALLATION».) Front side trim (See «FRONT SIDE TRIM REMOVAL/INSTALLATION».) Side panel (passenger's side)(See «SIDE PANEL REMOVAL/INSTALLATION».) Side wall (See «SIDE WALL REMOVAL/INSTALLATION».) Front console (See «FRONT CONSOLE REMOVAL/INSTALLATION».) Glove compartment (See «GLOVE COMPARTMENT REMOVAL/INSTALLATION».) Undercover Hood release lever (See «HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION».) Lower panel (See «LOWER PANEL REMOVAL/INSTALLATION».) Knee bolster Center panel unit (See «CENTER PANEL MODULE REMOVAL/INSTALLATION».) Selector lever component (See «SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION»(/mazda/5/i-2007-2010/remont/automatic-trans/#automatic-transaxle-shift-mechanism).) Driver-side air bag module (See «DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION».) Steering wheel (See «STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION».) Combination switch (See «COMBINATION SWITCH REMOVAL/INSTALLATION».) Meter hood (See «METER HOOD REMOVAL/INSTALLATION».) Lower column cover (See «COLUMN COVER REMOVAL/INSTALLATION».) Instrument cluster (See «INSTRUMENT CLUSTER REMOVAL/INSTALLATION».) Steering shaft (See «STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION».) A-pillar trim (See «A-PILLAR TRIM REMOVAL/INSTALLATION».) Climate control unit (See «CLIMATE CONTROL UNIT REMOVAL/INSTALLATION [FULL-AUTO AIR CONDITIONER]».)(See «CLIMATE CONTROL UNIT REMOVAL [MANUAL AIR CONDITIONER]».)(See «CLIMATE CONTROL UNIT INSTALLATION [MANUAL AIR CONDITIONER]».) Rear heater duct (1) (See «REAR HEAT DUCT REMOVAL/INSTALLATION».) Windshield wiper arm and blade (See «WINDSHIELD WIPER ARM AND BLADE REMOVAL/INSTALLATION».) Cowl grille (See «COWL GRILLE REMOVAL/INSTALLATION»(/mazda/5/i-2007-2010/remont/exteriorinterior-trim/#exterior-trim).)
4. Disconnect the dashboard harness connectors.
5. Remove in the order indicated in the figure.
6. Install in the reverse order of removal.

Scheme 6

See also:
• SAIL GARNISH REMOVAL/INSTALLATION
• SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION