Washer System & Wiper System: Other Mazda 5 I

Without Using WDS or Equivalent

Note. Perform initial setting in the following cases: The windshield is replaced but the rain sensor is reused. If the ignition switch is turned to the ON position with water or dirt on the windshield when replacing the rain sensor.

1. Remove water and dirt from the windshield surface.
2. Turn the ignition switch off.
3. Turn the windshield wiper switch to the AUTO position.
4. Within 10 s after turning the ignition switch to the ON position, turn the windshield wiper switch from the AUTO to the OFF position for five times and return it to the AUTO position. CAUTION: If the operation is too fast, the windshield wiper switch position cannot be detected and the initial setting may not be performed. Operate the windshield wiper switch for one cycle (AUTO-->OFF-->AUTO) per 1 s. NOTE: When the initial setting is performed correctly, the windshield wiper operates once at low speed.

Scheme 39

1. Connect the WDS or equivalent to the DLC-2 (16-pin).
2. Select 'Electrical' from the menu.
3. Select 'Rain Sensor Reset' and perform the procedure as indicated on the screen.