2000: PROTEGE
Note. Disconnecting battery will reset memory. DO NOT disconnect battery during and after drive cycle procedure. Vehicle speed and engine speed detected by PCM may differ from that indicated by speedometer and tachometer. Check vehicle speed and engine speed during drive cycle procedure using scan tool. If OBD-II system check is not completed during a drive cycle procedure, OBD-II system detects a malfunction or drive cycle was not completed correctly.
Check RFC FLAG PID. If PID is on, go to Mode 2. If PID is off, complete Mode 1 before performing Mode 2 or 3. Connect scan tool. Turn all accessories off. Start engine. Allow engine to reach operating temperature. Ensure idle speed and timing are within specification. With vehicle in Park or neutral, raise engine speed to 2300-2700 RPM for more than 15 seconds. Raise engine speed to 3800-4200 RPM for more than 15 seconds. Release throttle and allow to idle for 20 seconds. Ensure cooling fan does not operate during idle portion of cycle. Turn ignition off. Turn ignition on. Using scan tool, check drive mode completion status. If cycle is not complete, repeat cycle from engine start.
Connect scan tool. Check RFC FLAG PID. If PID is off, complete Mode 1 before performing Mode 2 or 3. If PID is on, start engine. Allow engine to reach operating temperature. Turn all accessories off. Drive vehicle at 50-60 MPH (in Drive for A/T, 5th for M/T) for at least one minute. Stop vehicle. Using scan tool, check drive mode completion status. If cycle is not complete, turn ignition off. Repeat test. If cycle is complete, check test results. If results are okay, ensure no DTCs are present. If results are not okay, repairs are not complete.
Connect scan tool. Check RFC FLAG PID. If PID is off, complete Mode 1 before performing Mode 2 or 3. If PID is on, start engine. Allow engine to reach operating temperature. Turn all accessories off. Drive vehicle for at least 5 minutes. Drive vehicle at more than 50 MPH (in Drive for A/T, 5th for M/T) for one minute. Drive vehicle at 40-60 MPH (in Drive for A/T, 5th for M/T) for 3 minutes. Stop vehicle. Using scan tool, check drive mode completion status. If cycle is not complete, turn ignition off. Repeat test. If cycle is complete, check test results. If results are okay, ensure no DTCs are present. If results are not okay, repairs are not complete.
Connect scan tool. Ensure BARO is 21.3 in. Hg. or more, IAT PID is 50-140°F (10-60°C) and FTL V PID is 0.5-2.5 volts. Ensure ECT PID is 14-72°F. If BARO PID is more, upper limit for ECT is more (BARO PID of 25.1 in. Hg. equals 90°F ECT limit). Turn all accessories off. Start engine. Raise engine speed to 3500 RPM for 200 seconds. Release throttle and allow to idle. Drive vehicle immediately. Accelerate from idle to 40-60 MPH within 20 seconds. Ensure 40-60 MPH is reached within 4 minutes of initial start. Drive vehicle steadily at 40-60 MPH for at least 2 minutes. Stop vehicle and allow to idle. Using scan tool, check drive mode completion status. If test is not complete, turn ignition off and repeat test. If test is complete, check test results. If results are okay, ensure no DTCs are present. If results are not okay, repairs are not complete.