Home/Mazda/3/Mazda 3 BL рестайлинг (2011-2013)/Repair manual/Electronic Steering/General Procedures - Steering System: Removal & Installation

Contents

Section: Electronic Steering

Electronic Power Steering - Electro Hydraulic Power Assist Steering (Ehpas) System: Overview
Electronic Power Steering - Electro Hydraulic Power Assist Steering (Ehpas) System: Adjustments
Electronic Power Steering - Electro Hydraulic Power Assist Steering (Ehpas) System: Diagnosis
Electronic Power Steering - Electro Hydraulic Power Assist Steering (Ehpas) System: Removal & Installation
Electronic Power Steering - Electro Hydraulic Power Assist Steering (Ehpas) System: Overhaul
Electronic Power Steering - Electro Hydraulic Power Assist Steering (Ehpas) System: Other

All sections

General Procedures - Steering System: Removal & Installation Mazda 3 BL рестайлинг

Electronic Steering

Suspension Links Removal/Installation

For the joint sections with rubber bushings, raise the vehicle using a lift, and then temporarily tighten the installation bolts and nuts. Lower the vehicle to the ground and tighten them completely with the specified torque.

If any power steering fluid line has been disconnected, perform the following after installation of the power steering components. (See «AIR BLEEDING»(ref-520445-S32260696292013010300000) .) (See «POWER STEERING FLUID INSPECTION»(ref-520445-S27716686472013010300000) .) Power steering fluid amount inspection Power steering fluid leakage inspection Air bleeding