AIR BLEEDING
| CAUTION | Do not maintain the steering wheel fully turned for 5 s or more. It is possible that oil temperature can rise and this will negatively affect the oil pump. |
- Inspect the fluid level. See «POWER STEERING FLUID INSPECTION»(ref-177673-S03244717802005060300000) .
- Turn the steering wheel fully to the left and right several times.
- Re-inspect the fluid level. If the fluid level has dropped, add fluid.
- Repeat Steps 2 - 3 until the fluid level stabilizes.
- Start the engine and let it idle.
- Turn the steering wheel fully to the left and right several times.
- Repeat Step 6 until the fluid is not foamy and the fluid level has not dropped.
- Inspect the fluid level, and if the fluid level has dropped, add fluid to a level between MAX and MIN of the reserve tank.
ELECTRO HYDRAULIC POWER ASSIST STEERING (EHPAS) CONTROL MODULE CONFIGURATION
- Turn the ignition switch off.
- Connect the WDS or equivalent to the DLC-2.
- Input the vehicle information following the directions on the screen of the WDS or equivalent.
- Select "Module Programming" from the WDS or equivalent menu.
- Select "Programmable Module Installation".
- Select "EPS".
- Clear DTCs using the WDS or equivalent, the verify that there is no DTC present.
