REMOVAL AND INSTALLATION
- Disconnect the accelerator pedal sensor electrical connector.
- Remove the 3 nuts and the accelerator pedal and sensor assembly. To install, tighten to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
Home/Lincoln/MKX/Lincoln MKX I (2006-2010)/Repair manual/Engine Control Systems/Acceleration Control System: Removal & Installation
Contents
Wiring diagrams Section: Engine Control Systems All sections- Abbreviations
- Accessories Control Systems
- Accessory Drive Belts
- Airbag
- Anti-Lock/traction Control
- Automatic Trans
- Auxiliary Emission Control Systems
- Axle Shafts
- Basic Trouble Shooting
- Body Electrical
- Brakes
- Cabin Air Filter
- Charging System
- Check Lists
- Collision/avoidance
- Communication Devices
- Cooling System (Mechanical)
- Cruise Control Systems
- Diagnostic Connector Locations
- Differentials & Drive Axles
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- Driveshaft & Universal Joints
- DTC Index
- Electrical
- Electrical Component Locations
- Emission Applications
- Engine
- Engine Control Systems
- Engine Performance
- Entertainment Systems
- Exhaust
- Exterior Body Panels
- Exterior Lights
- Exterior/interior Trim
- Frames, Subframes & Crossmembers
- Fuel System
- Gauges & Instrument Panels
- Hoist/jack
- Horns
- Identification
- Ignition System
- Interior/illumination Lights
- Manual & Power Steering
- Manual HVAC System
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Mode 6
- Oem General Information
- Parking Brake System
- Pin Voltage Charts
- Removal & Installation
- Reset Procedures
- Restraints Control Systems
- Schedule
- Seats
- Specifications
- Starter
- Steering
- Steering Column
- Steering Column Switches
- Sun Roof/t-Top/convertible Top
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Traction Control Disable
- Transfer Case
- Transmission
- Wheel & Tire System
- Windows
- Wiper/washer Systems