REMOVAL & INSTALLATION
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery. |
Unplug harness connectors at rear of mirror. Grasp mirror firmly, insert Mirror Remover (T91T-17700-A) or screwdriver into slot and press retaining spring. Slide mirror upward and away from mounting bracket. To install, reverse removal procedure.
Disconnect negative battery cable. Remove door trim panel. Disconnect mirror harness connector. Remove mirror attaching screws. Remove mirror assembly while guiding wiring and connector through hole in door. To install, reverse removal procedure.
Removal
- Rotate mirror glass to maximum upward travel. Insert flat blade screwdriver between mirror shell and glass on bottom edge about 1" from lower inside corner of glass. (Scheme 13) Place hand and shop towel over mirror glass, to keep it from falling out.
- Gently pry downward on screwdriver until snap is hear and mirror glass loosens from mirror motor. If glass does not come loose, move screwdriver to lower outside corner of mirror about 1" from outside corner. Gently pry downward. Glass will snap out without being damaged. Remove motor attaching screws. Disconnect motor connector, and remove motor.
Installation
Connect motor harness connector. Place motor in mirror shell and install mounting screws. Align mirror glass locating tabs with slots in mirror motor. Place shop towel over glass. Press inward with the palm of the hand until glass locks in place.
Scheme 13
Disconnect negative battery cable. Remove screw retaining power window switch bezel. Lift bezel to expose harness connector. Unplug electrical connector. Remove switch. Reverse removal procedure to install.