GENERATOR SPECIFICATIONS
| Application | Specification | ||
|---|---|---|---|
| Brush Length | |||
| Standard | 0.374-0.453 in. (9.5-11.5 mm) | ||
| Limit (Minimum) | 0.059 in. (1.5 mm) | ||
| Rotor | |||
| Resistance (1) | 2.1-2.5 Ohms | ||
| Slip Ring Diameter | |||
| Standard | 0.559-0.567 in. (14.2-14.4 mm) | ||
| Minimum | 0.504 in. (12.8 mm) | ||
| Generator Regulated Output | |||
| Amperage | |||
| Without Load | 10 Or Less Amps | ||
| With Load | 30 Or More Amps | ||
| Voltage (1) | 13.2-14.8 Volts | ||
| (1) Measured @ 68°F (20°C). | |||
| (1) | Measured @ 68°F (20°C). |
GENERATOR SPECIFICATIONS
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Generator Bolt | 29 (39) | |
| Generator Pulley Nut | 81 (110) | |
| Power Steering Pulley Nut | 32 (43) | |
| INCH Lbs. (N.m) | ||
| Battery Wire Terminal Nut | 58 (6.5) | |
| Generator Brush Holder Assembly Screw | 18 (2.0) | |
| Generator Holder With Rectifier | 26 (2.9) | |
| Generator Rectifier End Frame Nut | ||
| Without Cord Clip | 40 (4.5) | |
| With Cord Clip | 48 (5.4) | |
| Rear End Cover | ||
| Bolt | 34 (3.8) | |
| Nut | 39 (4.4) | |
TORQUE SPECIFICATIONS