GENERATOR SPECIFICATIONS
| Application | Specification | ||
|---|---|---|---|
| Brush Length | |||
| Standard | .413 in. (10.5 mm) | ||
| Limit (Minimum) | More Than .177 in. (4.5 mm) | ||
| Rotor | |||
| Resistance (1) | |||
| 100-Amp | 2.3-2.7 Ohms | ||
| 130-Amp | 1.5-1.9 Ohms | ||
| Slip Ring Diameter | |||
| Standard | .559-.567 in. (14.2-14.4 mm) | ||
| Minimum | .551 in. (14.0 mm) | ||
| Generator Regulated Output | |||
| Amperage | |||
| Without Load | 10 Or Less Amps | ||
| With Load | 30 Or More Amps | ||
| Voltage (1) | 13.2-14.8 Volts | ||
| (1) Measured @ 68°F (20°C). | |||
| (1) | Measured @ 68°F (20°C). |
GENERATOR SPECIFICATIONS
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Generator Adjusting Bolt | 13 (18) |
| Generator Pivot Bolt | 43 (58) |
| Generator Pulley Nut | 81 (110) |
| INCH Lbs. (N.m) | |
| Battery Wire Terminal Nut | 87 (9.8) |
| Generator Coil Assembly Bolt | 51 (5.8) |
| Generator Brush Holder Assembly Screw | 16 (1.8) |
| Generator Rear End Cover Nut | 41 (4.6) |
TORQUE SPECIFICATIONS