REMOVAL & INSTALLATION
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery. |
Removal
Note. Perform this operation with battery negative (-) cable connected to the battery terminal.
- Turn the ignition switch to LOCK position.
- Remove the antenna nut.
- Press the AM and CD buttons on the radio receiver and simultaneously turn the ignition switch to ACC position.
- Press the AM and Tape buttons on the radio receiver, and simultaneously turn the ignition switch to ACC position.
Installation
- Insert the cable of the rod until it reaches the bottom. (Scheme 1) When inserting the cable, the teeth on the cable must face toward the rear of the vehicle.
- Wind the cable to retract the rod by running the ignition switch to LOCK position. If the ignition switch is already in LOCK position perform removal procedure first, then turn the ignition switch to ACC position. In case the cable is not wound, twist it. (Scheme 2) Even if the rod has not retracted fully, install the antenna nut and inspect the antenna rod operation. It will finally retract fully.
- Inspect the antenna rod operation by pushing the radio wave band select buttons.
