REMOVAL & INSTALLATION
| WARNING | Vehicles are equipped with air bag supplemental restraint system. Before attempting any repairs involving steering column, instrument panel or related components, see SERVICE PRECAUTIONS and DISABLING & ACTIVATING AIR BAG SYSTEM in appropriate AIR BAG RESTRAINT SYSTEMS article. |
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See appropriate COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery. |
Removal
- Using a screwdriver, remove the inner rear view mirror stay holder cover. (Scheme 6)
- Disconnect the connector.
- Remove the mirror assembly by turning the stay part of the mirror counterclockwise. (Scheme 7)
Scheme 6
Scheme 7
Installation
- Match the claw part of the mirror with a cut part of the base.
- Turn the stay part of the mirror clockwise so that the stay can come to the original position, and then install the mirror assembly.
- Connect the inner rear view mirror connector.
- Remove the front door trim panel. See DOOR TRIM PANEL (FRONT) under REMOVAL & INSTALLATION under «POWER DOOR LOCKS & TRUNK LID»(ref-154728) article in DOOR LOCKS & ANTI-THEFT SYSTEMS.
- Remove the front No. 2 speaker by disconnecting the connector and removing the 2 bolts. (Scheme 8)
- Remove the outer side view mirror by disconnecting the connector and removing the bolt.
- For installation, reverse the removal procedure. See «TORQUE SPECIFICATIONS»(ref-154820-S26167821932003052800000) table.
