PROCEDURE
- CHECK FOR DTC Delete the DTC. Check for DTCs again. OK No DTC is output. NG --> REPLACE POWER SOURCE CONTROL ECU OK --> END
- CHECK FOR DTC (EACH SYSTEM) Delete the DTCs. HINT: After all DTCs are cleared, check if the trouble occurs again 5 seconds after the power switch is turned ON (IG). Check for DTCs again. RESULT Result Proceed to DTC is not output A DTC is output B HINT: "Each system" means the smart access system and engine immobiliser system. B --> GO TO THE APPROPRIATE DTC CHART A --> GO TO THE APPROPRIATE SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Door Lock) SERVICE INFORMATION
- CHECK FOR DTC Delete the DTCs. HINT: After all DTCs are cleared, check if the trouble occurs again 5 seconds after the power switch is turned ON (IG). Check for DTCs again. OK No DTC is output. NG --> GO TO THE APPROPRIATE DTC CHART OK: Go to next step
- CHECK BASIC FUNCTION When the key is inside the vehicle and the shift lever position is in P, check that depressing the brake pedal causes the power switch indicator to illuminate green. Result Result Proceed to Indicator illuminates green A Power switch indicator circuit is normal but indicator does not illuminate green B Room oscillator recognizes key but indicator does not illuminate green C C --> GO TO POWER SWITCH INDICATOR CIRCUIT. Refer to «Power Switch Indicator Circuit»(ref-387106-S02745034452011022400000) . B --> GO TO ROOM OSCILLATOR DOES NOT RECOGNIZE KEY. Refer to «ROOM OSCILLATOR DOES NOT RECOGNIZE KEY»(ref-387107-S04996201732011022400000) . A --> REPLACE POWER SOURCE CONTROL ECU