Power Windows: Removal & Installation Lexus ES XV20

Removal & Installation (Front)

1. Disconnect negative battery cable. Remove bezel from inner door handle by removing screw. Remove window switch. Remove screw beneath window switch. Remove screw cover and screw from upper front corner of door panel.
2. Pry door trim panel away from door to release retainer clips. Pull door trim panel upward to disengage it from door, then disconnect electrical connectors.
3. Remove speaker. Remove door belt molding from top edge of door. Carefully remove door weatherstrip (do not pull hard; use a clip remover to disengage clips).
4. Remove small speaker and outside rear view mirror. Remove inside door handle assembly (remove screw and disengage 2 links). Carefully pull water shield away from door. Disconnect and remove lock link rods. Remove 2 glass upper stops.
5. Remove 3 glass mounting nuts, then carefully pull glass out of door. Disconnect window motor connector. Remove upper and lower window regulator mount bolts/nuts. Remove regulator and motor assembly. To install, reverse removal procedure.

Power Window System Wiring Diagram (ES300). Scheme 1