General
The rear fog lamps are incorporated within the light clusters mounted on the E post. The front fog lamps are mounted on either side of the bumper. The front fog lamps are operated by pressing the latching switch mounted in the center of the fascia. The rear fog lamps are operated by pressing the adjacent non-latching switch. Both switches contain a tell-tale LED to inform the driver the fog lamps are operational.
The fog lamps will only operate if the following conditions exist
BRAKE AND REVERSE LAMPS
- The ignition switch is turned to the 'ignition' position.
- The lighting switch is in the side or headlamp position.
- The relevant fascia mounted switch is pressed.
Note. The front fog lamps on NAS vehicles will not illuminate while headlamp main beam is operational.
Feed from the positive battery terminal (C0192) is supplied to fusible link 3, fusible link 9 and fusible link 12 of the engine compartment fuse box (C0632) on an R wire. Fusible link 9 (C0570) provides a constant battery feed to the main/dipped beam relay (NAS vehicles only) and fuse 30 of the passenger compartment fuse box (C0587) on an N wire.
Fusible link 3 (C0571) is connected to the ignition switch (C0028) by an N wire. When the ignition switch is tuned to the ignition position, current flows across the switch (C0028) to the front fog lamp relay coil (C0588) on a G wire. The relay is located in the passenger compartment fuse box and is earthed (C0589) on a B wire.
Fusible link 12 (C0575) is connected to the lighting switch (C0041) by an RN wire. Fusible link 12 (C0570) also provides a feed to the lighting switch (C0041) on a UN wire.
Lighting Switch
When the lighting switch is turned to the side lamp position, current flows across the switch (C0041) to fuse 39 of the passenger compartment fuse box (C0587) on an R wire. Fuse 39 (C0580) provides a feed to the front fog lamp relay (C2624) on an R wire.