Home ReviewsRefund
Home/Kia/Rio/Kia Rio III (2011-2015)/Repair manual/Door Locks & Anti-Theft Systems/Smart Key Code Saving (Button) Diagnosis: Other
Contents Wiring diagrams Section: Door Locks & Anti-Theft Systems All sections

Smart Key Code Saving (Button) Diagnosis: Other Kia Rio III

Door Locks & Anti-Theft Systems 4 illustrations ~374 words

Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, ECM/PCM status and Smartkey ECM/PCM status.
  2. Selet "Diagnostic Trouble Codes(DTCs)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 230

Scheme 230: Component Location
Scheme 230: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, ECM/PCM status and Smartkey ECM/PCM status.
  2. Selet "Diagnostic Trouble Codes(DTCs)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 231

Scheme 231: Component Location
Scheme 231: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, ECM/PCM status and Smartkey ECM/PCM status.
  2. Selet "Diagnostic Trouble Codes(DTCs)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 232

Scheme 232: Component Location
Scheme 232: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, ECM/PCM status and Smartkey ECM/PCM status.
  2. Selet "Diagnostic Trouble Codes(DTCs)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 233

Scheme 233: Component Location
Scheme 233: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, ECM/PCM status and Smartkey ECM/PCM status.
  2. Selet "Diagnostic Trouble Codes(DTCs)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

More articles — Smart Key Code Saving (Button) Diagnosis