Home ReviewsRefund
Home/Kia/Optima/Kia Optima III рестайлинг (2013-2015)/Repair manual/Door Locks & Anti-Theft Systems/Smart Key Code Saving (Button) Diagnosis - Optima Hev: Other
Contents Section: Door Locks & Anti-Theft Systems All sections

Smart Key Code Saving (Button) Diagnosis - Optima Hev: Other Kia Optima III рестайлинг

Door Locks & Anti-Theft Systems 4 illustrations ~382 words

Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTC)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 224

Scheme 224: Component Location
Scheme 224: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTC)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 225

Scheme 225: Component Location
Scheme 225: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTC)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 226

Scheme 226: Component Location
Scheme 226: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTC)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 227

Scheme 227: Component Location
Scheme 227: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTC)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

More articles — Smart Key Code Saving (Button) Diagnosis - Optima Hev