TPMS RESET - PROCEDURE 2
Note. In the following procedure, a TPMS sensor activation tool must be used. The manfacturer refers to their tool as a TPMS exciter scan tool.
Note. If tire pressure sensor is replaced, it will need to be initiated. The TPM system is not affected by wheel and tire rotation.
Note. Do not perform this procedure if vehicle is parked on a metal floor, roof, or on an alignment rack or lift. The metal will transfer the RF signals, which can cause the learn procedure to fail and set Diagnostic Trouble Codes (DTCs).
- Holding TPMS exciter within 3" (76 mm) of the sensor valve, read each tire pressure sensor ID in the following order: Front Left, Front Right, Rear Left, Rear Right.
- Connect TPMS exciter to Data Link Connector (DLC) located under left side of instrument panel. Register the 4 sensor IDs to receiver. (Схема №2)and (Схема №3).
- Disconnect TPMS exciter from diagnostic link. Cycle ignition and wait 4 minutes. Ensure "NORMAL RECEIVER STATE" is now displayed.
TPMS RESET - PROCEDURE 3
When the TPMS indicator illuminates, inflate tires to the specified pressure. After restarting, the TPMS indicator may flash for approximately 1 minute and then remain continuously illuminated. The indicator will go out after 20 minutes of continuous driving.
TPMS RESET - PROCEDURE 4
System Reset
There is no reset procedure necessary for this TPM system. Corrected tire inflation pressure will cause the TPMS indicator to shut off once the tire pressure sensor reports to the TPMS receiver, approximately 20 minutes after the vehicle stops moving, or 20 minutes of continuous driving.
Sensor Regitration
New tire pressure sensors must be registered to the TPM system. A Hyundai Global Diagnostic System (GDS) and GDS TPMS module are required to perform the sensor registration procedure. Select the model, then ID Register, then perform the sensor registration procedure according to instructions on the GDS.
TPMS RESET - PROCEDURE 5
There is no reset procedure necessary for this TPM system. Corrected tire inflation pressure will cause the TPMS indicator to shut off once the tire pressure sensor reports to the TPMS receiver, approximately 10 minutes of continuous driving at over 15 mph.
New tire sensors are Auto-Learned. Auto-Learning only functions when speed is more than 15 mph for at least 10 minutes.
Note. A Hyundai Global Diagnostic System (GDS) can also perform the sensor registration procedure. Select the model, then ID Register, then perform the sensor registration procedure according to instructions on the GDS.