Home ReviewsRefund
Home/Jeep/Compass/Jeep Compass I (2006-2010)/Repair manual/Ignition System/Ignition Control - Service Information: Removal & Installat…
Contents Wiring diagrams Section: Ignition System All sections

Ignition Control - Service Information: Removal & Installation Jeep Compass I

Ignition System ~117 words

OIL CONTROL VALVE REMOVAL

  1. Solenoid for front location 1/1. Note mounting tab location is different between front and rear solenoids.
  2. Install solenoid into cylinder head.
  3. Install mounting bolt and tighten to 12 N.m (9 ft. lbs.).
  4. Install oil pressure sensor.
  5. Connect electrical connector to oil pressure sensor.
  6. Connect electrical connector to Variable valve timing solenoid.
  7. Connect negative battery cable.
  8. Install engine cover.
  1. Rear variable valve timing solenoid. Note mounting tab location is different between front and rear solenoids.
  2. Install solenoid into cylinder head.
  3. Install mounting bolt and tighten to 12 N.m (9 ft. lbs.).
  4. Connect electrical connector to Variable valve timing solenoid.
  5. Connect negative battery cable.
  6. Install engine cover.

More articles — Ignition Control - Service Information