Continuously Variable Transmission (Cvt) - Service Information: Specifications Jeep Compass I

TORQUE CONVERTER SEAL

1. Remove transmission. See «REMOVAL»(ref-304401-S36790110272008110700000) .
2. Remove torque converter.
3. Remove torque converter seal using Slide Hammer C-3752 and oil Seal Remover 9667.

1. Install torque converter seal using oil seal Installer 9858. NOTE: Gauge Bar 6311 can be used for doing the following measurement. NOTE: When conducting measurements, measure two or more places and calculate the average value.
2. Install the torque converter on the transaxle and measure the dimension (1) to see if it is at least 13 mm. If the measurement is less than 13 mm, the torque converter is not fully installed. (Схема №187) NOTE: Use the designated brand of CVT fluid. Use of other brands of CVT fluid other than the designated brand will deteriorate the driveability and the durability of the CVT, and will cause damage to the CVT.
3. Install the transmission. See «INSTALLATION»(ref-304401-S07338837582008110700000).