Home ReviewsRefund
Home/Jeep/Compass/Jeep Compass I рестайлинг 2 (2013-2016)/Repair manual/Body Electrical/Circuit Testing Procedures - Non-Dtc-Based Diagnostics: Rem…
Contents Section: Body Electrical All sections

Circuit Testing Procedures - Non-Dtc-Based Diagnostics: Removal & Installation Jeep Compass I рестайлинг 2

Body Electrical ~106 words

CONNECTOR TERMINAL INSTALLATION

  1. Select a wire from the terminal repair kit that best matches the color and gauge of the wire being repaired.
  2. Cut the repair wire to the proper length and remove one-half (1/2) inch of insulation.
  3. Splice the repair wire to the wire harness (refer to «WIRE SPLICING»(ref-612784-S36647621282014043000000) ).
  4. Insert the repaired wire into the connector.
  5. Install the connector locking wedge, if required, and reconnect the connector to its mating half/component.
  6. Re-tape the wire harness starting at 1-1/2 inches behind the connector and 2 inches past the repair.
  7. Connect battery and test all affected systems.

More articles — Circuit Testing Procedures - Non-Dtc-Based Diagnostics