NV140 Transfer Case - Service Information: Maintenance Jeep Commander I

FLUID DRAIN/REFILL

1. Raise vehicle.
2. Remove the bolts (1) holding the damper (2) to the rear case (3). (Схема №3) 1 - DAMPER 2 - REAR HOUSING
3. Remove the damper (1) from the rear case (2). (Схема №4) 1 - I.D. TAG 2 - FILL PLUG 3 - DRAIN PLUG NOTE: The fill (2) and drain (3) plugs are both in the rear case. (Схема №62)
4. Position drain pan under transfer case.
5. Remove drain and fill plugs and drain lubricant completely.
6. Install drain plug. Tighten plug to 20-34 N.m (15-25 ft. lbs.).
7. Remove drain pan.
8. Fill transfer case to bottom edge of fill plug opening with the required fluid. Refer to «DESCRIPTION»(ref-288217-S21119506662008062000000).
9. Install and tighten fill plug to 20-34 N.m (15-25 ft. lbs.). 1 - DAMPER 2 - REAR HOUSING
10. Install the transfer case damper (1) onto the rear case (2). (Схема №46) 1 - BOLTS 2 - DAMPER 3 - REAR HOUSING
11. Install the bolts (1) to hold the damper (2) to the rear case (3). Tighten the bolts to 27 N.m (20 ft. lbs.). (Схема №47)
12. Lower vehicle.