PRINCIPLES OF OPERATION
The windshield and coupe backlight are supplied as assemblies complete with trim, which is directly bonded to the glass.
The convertible backlight is high frequency welded to the canopy and the outer seal is stitched and bonded to the top. On both models, the heated backlight remains on for 21 minutes after being switched on unless it is manually switched off before the time delay expires.
| Item Number | Description |
|---|---|
| 1 | Front door glass |
| 2 | 'A' pillar guide rail |
| 3 | Window motor |
| 4 | Bowden cables |
| 5 | 'B' pillar guide rail |
One-touch up operation causes the door glass to fully close unless an object is detected ('Anti-trap') or the glass is within 45 mm of top of travel when the door is opened. If the 'Anti-trap' regulator detects an object, the glass will drop fully open or to 200 mm below the obstruction. All door glass operates with the ignition in either 'Accessory' mode or 'On' mode and after the ignition enters 'Off' mode, until either door is opened.
The front windows must be programmed for one-touch operation in order for the convertible top to operate correctly. Failure to program the windows results in a 10 second opening delay once the top is unlatched. The windows can be manually programmed for one-touch operation using the following procedure
- Engine running
- Raise window up to the top seal and release switch
- Raise again until window stops moving
- Release switch
- Raise again
- Lower window fully
- Release switch
- Press lower for a further 0.5 seconds until a relay is heard to CLICK
Note. Before commencing work within a door interior, all Warnings and Notes within the appropriate Removal and Installation procedures must be read and fully understood.
To re-learn the glass operating characteristics, the associated door must be closed (door ajar switch inactive). The glass must then be driven fully down and held stalled at the bottom of its travel for a minimum of 1 second. The glass is finally driven to the fully up position and held stalled for a minimum of 1 second. The re-learning procedure must also be accomplished to regain the automatic glass closing sequence.
PRINCIPLE OF OPERATION
For a detailed description of the Glass, Frames and Mechanisms, refer to Glass, Frames and Mechanisms .
For a detailed description of the Glass, Frames and Mechanisms and operation, refer to the relevant Description and Operation information.