Contents Wiring diagrams Section: Transfer Case All sections

Transfer: Specifications Infiniti M45 III

Specifications with CONSULT-II

Monitor item [Unit]ContentConditionDisplay value
FR RH SENSOR [km/h] or [mph]Wheel speed (Front wheel right)Vehicle stopped0.00 km/h (0.00 mph)
Vehicle running CAUTION: Check air pressure of tire under standard condition.Approximately equal to the indication on speedometer (Inside of +/-10%)
FR LH SENSOR [km/h] or [mph]Wheel speed (Front wheel left)Vehicle stopped0.00 km/h (0.00 mph)
Vehicle running CAUTION: Check air pressure of tire under standard condition.Approximately equal to the indication on speedometer (Inside of +/-10%)
RR RH SENSOR [km/h] or [mph]Wheel speed (Rear wheel right)Vehicle stopped0.00 km/h (0.00 mph)
Vehicle running CAUTION: Check air pressure of tire under standard condition.Approximately equal to the indication on speedometer (Inside of +/-10%)
RR LH SENSOR [km/h] or [mph]Wheel speed (Rear wheel left)Vehicle stopped0.00 km/h (0.00 mph)
Vehicle running CAUTION: Check air pressure of tire under standard condition.Approximately equal to the indication on speedometer (Inside of +/-10%)
BATTERY VOLT [V]Power supply voltage for AWD control unitIgnition switch: ONBattery voltage
THRTL POS SEN [%]Throttle opening conditionWhen depressing accelerator pedal (Value rises gradually in response to throttle position.)0 - 100%
ETS SOLENOID [A]Monitored value of current at AWD solenoidEngine running At idle speedApprox. 0.000A
Engine running When depressing accelerator pedalApprox. 0.000 - 0.500A (1)
STOP LAMP SW [ON/OFF]Condition of brake pedal operationBrake pedal: DepressedON
Brake pedal: ReleasedOFF
ENG SPEED SIG [RUN/STOP]Condition of engine runningEngine stopped (Engine speed: Less than 400 rpm)STOP
Engine running (Engine speed: 400 rpm or more)RUN
ETS ACTUATOR [ON/OFF]Operating condition of AWD actuator relay (integrated in AWD control unit)Engine stopped (Ignition switch: ON)OFF
Engine runningON
4WD WARN LAMP [ON/OFF]AWD warning lamp conditionAWD warning lamp: ONON
AWD warning lamp: OFFOFF
4WD MODE SW (2) [AUTO]Input condition from mode switchAlwaysAUTO
4WD MODE MON [AUTO]Control status of AWDEngine runningAUTO
DIS-TIRE MONI [mm]Improper size tire installed conditionVehicle running with normal size tire installed0-4 mm
Vehicle running with improper size tire installed (Front/rear tire size difference, wear condition)4-8 mm, 8- mm
P BRAKE SW [ON/OFF]Condition of parking brakeParking brake operatedON
Parking brake not operatedOFF
(1) The values are changed by throttle opening and engine speed. (2) Mode switch is not equipped, but displayed.
CAUTION
Check air pressure of tire under standard condition.
CAUTION
Check air pressure of tire under standard condition.
CAUTION
Check air pressure of tire under standard condition.
CAUTION
Check air pressure of tire under standard condition.
(1)The values are changed by throttle opening and engine speed.
(2)Mode switch is not equipped, but displayed.

SPECIFICATIONS WITH CONSULT-II CHART

General Specifications

Applied modelVQ35DE
Transfer modelETX13B
Fluid capacity (Approx.)1.25 l (2-5/8 US pt, 2-1/4 lmp pt)

GENERAL SPECIFICATIONS