Home ReviewsRefund
Home/Infiniti/M37/Infiniti M37 IV (2010-2014)/Repair manual/Procedures/Maintenance: Removal & Installation
Contents Wiring diagrams Section: Procedures All sections

Maintenance: Removal & Installation Infiniti M37 IV

Procedures 5 illustrations ~225 words

INSTALLATION

Note the following, and install in the reverse order of removal.

  1. Install the air cleaner filter by aligning the seal with the notch of air cleaner case.

REMOVAL

CAUTIONOil filter is provided with relief valve. Use genuine NISSAN oil filter or equivalent. Be careful not to get burned when engine and engine oil may be hot. When removing, prepare a shop cloth to absorb any engine oil leakage or spillage. Never allow engine oil to contact drive belt. Completely wipe off any engine oil that spills on engine and vehicle.

Scheme 19

Scheme 19
Scheme 19

Scheme 20

Scheme 20
Scheme 20
  1. Remove engine undercover with power tool.
  2. Using oil filter wrench [SST: KV10115801 (J-38956)] (B), remove oil filter.

Scheme 21

Scheme 21: INSTALLATION
Scheme 21: INSTALLATION

Scheme 22

Scheme 22
Scheme 22
  1. Remove foreign materials adhering to oil filter installation surface.
  2. Apply engine oil to the oil seal contact surface of new oil filter.
  3. Screw oil filter manually until it touches the installation surface, then tighten it by 2/3 turn (A). Or tighten to the specification. Oil filter: Torque: 17.7 N.m (1.8 kg-m, 13 ft-lb)

Installation is the reverse order of removal.

Note the following item, and install in the reverse order of removal.

  1. Install the air cleaner filter by aligning the seal with the notch of air cleaner case.
CAUTIONOil filter is provided with relief valve. Use genuine NISSAN oil filter or an equivalent. Be careful not to get burned when engine and engine oil may be hot. When removing, prepare a shop cloth to absorb any engine oil leakage or spillage. Never allow engine oil to contact drive belts. Completely wipe off any engine oil that spills on engine and vehicle.

Scheme 23

Scheme 23
Scheme 23
  1. Remove engine undercover with power tool.
  2. Using oil filter wrench [SST: KV10115801 (J38956)] (A), remove oil filter.
  1. Remove foreign matter adhering to oil filter installation surface.
  2. Apply engine oil to the oil seal contact surface of new oil filter.
  3. Screw oil filter manually until it touches the installation surface, then tighten it by 2/3 turn (A). Or tighten to the specification. Oil filter: Torque: 17.7 N.m (1.8 kg-m, 13 ft-lb)

Installation is the reverse order of removal.

More articles — Maintenance