Adjustment
| CAUTION | Always maintain the ATF temperature within between 35°C (95°F) and 45°C (113°F) while checking with CONSULT-III when the ATF level adjustment is performed. |
- Start the engine.
- Make the ATF temperature approximately 40°C (104°F). NOTE: The ATF level is greatly affected by the temperature. Always check the ATF temperature on "ATF TEMP 1" in "Data Monitor" using CONSULT-III.
- Park vehicle on level surface and set parking brake.
- Shift the selector lever through each gear position. Leave selector lever in "P" position.
- Lift up the vehicle.
- Check the ATF leakage from transmission.
- Remove overflow plug from oil pan.
- Insert the own made tube into the overflow plug hole, and then fill approximately 0.5 liters (1/2 US qt, 1/2 lmp qt) of the ATF.
- Check that the ATF leaks when removing the own made tube from the overflow plug hole. If the ATF does not leak, refill the ATF.
- When the ATF starts to drop, tighten the overflow plug into the oil pan to the specified torque. CAUTION: Never reuse overflow plug. Overflow plug - tightening torque : Refer to " «EXPLODED VIEW»(ref-368808-S29165757112010081300000) ".
ADJUSTMENT AFTER INSTALLATION
Adjust A/T position. Refer to " 2WD : INSPECTION AND ADJUSTMENT " (2WD models), " AWD : INSPECTION AND ADJUSTMENT " (AWD models).
Adjust A/T fluid level. Refer to " ADJUSTMENT ".
Adjust A/T fluid level. Refer to " ADJUSTMENT ".
Adjust A/T fluid level. Refer to " ADJUSTMENT ".
Adjust A/T fluid level. Refer to " ADJUSTMENT ".
Adjustment A/T fluid level. Refer to " ADJUSTMENT ".
Adjustment A/T fluid level. Refer to " ADJUSTMENT ".
Adjust A/T fluid level. Refer to " ADJUSTMENT ".
Adjust A/T fluid level. Refer to " ADJUSTMENT ".