Installation
- Install the multifunction switch.
- Install the clock spring.
- Install the steering column upper and lower shrouds.
- Install the steering wheel. NOTE: Make sure the multifunction switch connectors are plugged in properly.
Home/Hyundai/Veloster/Hyundai Veloster I (2011-2015)/Repair manual/Steering Column Switches/Multifunction Switch: Removal & Installation
Contents
Wiring diagrams Section: Steering Column Switches- Multifunction Switch: Specifications
- Multifunction Switch: Diagnosis
- Multifunction Switch: Removal & Installation
- Abbreviations
- Airbag
- Anti-Lock/traction Control
- Automatic HVAC System
- Automatic Trans
- Axle Shafts
- Basic Trouble Shooting
- Blowers, Superchargers & Turbochargers
- Brakes
- Cabin Air Filter
- Charging System
- Check Lists
- Clutches Manual & Hydraulic
- Collision/avoidance
- Communication Devices
- Cooling System (Mechanical)
- Cruise Control Systems
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- DTC Index
- Electronic Steering
- Emission Applications
- Engine
- Engine Performance
- Entertainment Systems
- Exhaust
- Exterior Body Panels
- Exterior Lights
- Frames, Subframes & Crossmembers
- Fuel System
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- Heated Glass/defoggers
- Heater
- Horns
- Identification
- Ignition System
- Lubrication System
- Manual & Power Steering
- Manual HVAC System
- Manual Trans
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Navigation System
- Oem General Information
- Parking Brake System
- Passive Restraints
- Reset Procedures
- Seats
- Specifications
- Starter
- Steering
- Steering Column Switches
- Sun Roof/t-Top/convertible Top
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Traction Control Disable
- Transmission
- Wheel & Tire System
- Wheel Alignment
- Wheel Hubs
- Windows
- Wiper/washer Systems