Installation of the transmitting device
Electronic-controlled computers are designed not to interrupted by other radio signal but it could be effected even less 25W output of remote-cont roll by wiring an antenna of it or the cables near the computer. Should follow below directions.
- equip an antenna at the roof or rear-bumber.
- Antenna cables should keep away over 200mm from the computer or wiring harness because the antenna cables transmit radio signals.
- decrease the standing-wave ratio by using proper antennas and cables.
- Not to install remote-control with a high output.
- check the status of a engine by generating radio signals with Idling. NOTE: The standing-wave ratio: Input impedance Zi can be changed by the length of cables and signals of the remote control under condition impedance connects with other cables, antennas and changeable also voltage range. This rate of the maximum and the minimum voltage is called the standing-wave ratio. This means that the rate of the antenna impedance and cable impedance. The volume of radio signals from cables is proportioned to the standing-wave ratio volume so that possibility which have an influence to the electronic part increases.