Home/Hyundai/Accent/Hyundai Accent I (1994-2000)/Repair manual/Mechanical/Removal & Installation: Overview

Contents

Wiring diagrams Section: Mechanical

Engine Identification

Timing Belt

Valve Clearance Adjustment

Intake Manifold

Front Cover Oil Seal

Thermostat

Cylinder Head

Valve Springs

Valve Stem Oil Seals

Valve Guides

Valve Seats

Valves

Hydraulic Lash Adjusters

Cylinder Block Assembly

Piston & Rod Assembly

Fitting Pistons & Rings

Piston Pin Replacement

Crankshaft & Main Bearings

Engine Lubrication System

Crankcase Capacity

Oil Pressure

Disassembly & Inspection

Reassembly & Installation

Pressure Relief Valve

General Specifications

Crankshaft, Main Bearings & Connecting Rod Bearings Specifications

Connecting Rods Specifications

Pistons, Piston Pins & Piston Rings Specifications

Cylinder Block Specifications

Engine Valves & Valve Springs Specifications

Cylinder Head Specifications

Camshaft Specifications

Torque Specifications

All sections

Removal & Installation: Overview Hyundai Accent I

Mechanical ~101 words

Remove idle speed actuator. Remove air intake hose connected to throttle body. Remove accelerator cable. Remove water hose and throttle body. NOTE: Label all wiring, hoses, cables and brackets before removal.
Remove PCV hose and brake booster vacuum hoses. Disconnect vacuum hose connections. Disconnect high pressure fuel hose. Remove plenum stay. Remove plenum assembly and gasket. Disconnect fuel injector harness connector. CAUTION: DO NOT drop injectors when removing delivery pipe.
Remove delivery pipe with fuel injectors and pressure regulator attached. Remove insulator from intake manifold, and disconnect heater hose. Remove intake manifold. To install, reverse removal procedure.