Home/Hummer/H2/Hummer H2 I рестайлинг (2007-2009)/Repair manual/Automatic HVAC System/Heating, Ventilation, and Air Conditioning: Specifications
Contents Section: Automatic HVAC System All sections

Heating, Ventilation, and Air Conditioning: Specifications Hummer H2 I рестайлинг

Fastener Tightening Specifications

ApplicationSpecification
MetricEnglish
A/C Accumulator Nut to Evaporator16 N.m12 lb ft
A/C Belt Tensioner Bolts50 N.m37 lb ft
A/C Low Pressure Switch6 N.m53 lb in
A/C Refrigerant Filter Retaining Nuts15 N.m11 lb ft
A/C Refrigerant Pressure Sensor6 N.m53 lb in
Accumulator Bracket Nut9 N.m80 lb in
Accumulator Clamp Bolt10 N.m8 lb ft
Air Distribution Duct Screws2 N.m18 lb in
Auxiliary Heater Core Bracket Screws2 N.m18 lb in
Air Distribution Housing Screws2 N.m18 lb in
Blower Motor Screws2 N.m18 lb in
Compressor Bracket Mounting Bolts50 N.m37 lb ft
Compressor Clutch Plate Retaining Bolt18 N.m13 lb ft
Compressor Discharge Hose to Condenser Nut16 N.m12 lb ft
Compressor Mounting Bolts50 N.m37 lb ft
Compressor Suction/Discharge Hose Bolt16 N.m12 lb ft
Compressor Suction Hose at Accumulator Nut16 N.m12 lb ft
Condenser Upper Insulator Retainer Bolts9 N.m80 lb in
Evaporator Core Cover Screws2 N.m18 lb in
Evaporator Tube Fitting at Orifice25 N.m18 lb ft
Evaporator Tube at Condenser Nut16 N.m12 lb ft
Evaporator Tube at Evaporator Nut16 N.m12 lb ft
Filter Access Door Screw2 N.m18 lb in
Floor Air Outlet Duct Screw1.6 N.m14 lb in
Heater Core Cover Screws2 N.m18 lb in
Hood Spring Mounting Bolt and Nut17 N.m13 lb ft
HVAC Module Mounting Bolts4 N.m35 lb in
HVAC Module Mounting Nuts9 N.m80 lb in
HVAC Module Screws2 N.m18 lb in
Mode Actuator Screws2 N.m18 lb in
Recirculation Actuator Screws17 N.m13 lb ft

Refrigerant System Capacities

ApplicationSpecification
MetricEnglish
PAG Oil GM P/N 12378526 for United States PAG Oil GM P/N 88900060 for Canada
Accumulator ReplacementMl*Oz*
*Add 60 ml (2 oz) of PAG oil, plus the equal amount of oil drained from the accumulator.
Compressor Replacement60 ml2 oz
The Denso replacement compressor is precharged with 237 ml (8.0 oz) of PAG oil.
Condenser Replacement30 ml1 oz
Evaporator Replacement90 ml3 oz
If more than the specified amount of PAG oil was drained from a component, add the equal amount drained.
Total System PAG Oil Capacity210 ml7.1 oz
R-134a
Refrigerant Charge0.7 kg1.6 lb