Home/Hummer/H2/Hummer H2 I (2002-2007)/Repair manual/Wheel Alignment/Wheel Alignment System: Specifications

Contents

Wiring diagrams Section: Wheel Alignment

All sections

Wheel Alignment System: Specifications Hummer H2 I

Wheel Alignment

Wheel Alignment Specifications

Caster		Cross Caster (L - R)	Camber	Cross Camber (L - R)	Total Toe	Steering Wheel Angle
Left	Right	Cross Caster (L - R)	Camber	Cross Camber (L - R)	Total Toe	Steering Wheel Angle
IMPORTANT: Caster is relative to frame. The caster values must be compensated for the measured frame angle. Frame angle is positive when higher in the rear and negative when lower in the rear. Refer to Front Caster and Camber Adjustment .
4.25° +/- 1.00°	4.75° +/- 1.00°	0.50° +/- 0.75°	+0.25° +/- 0.60°	0.00° +/- 0.60°	+0.10° +/- 0.20°	1.00° +/- 3.50°

IMPORTANT
Caster is relative to frame. The caster values must be compensated for the measured frame angle. Frame angle is positive when higher in the rear and negative when lower in the rear. Refer to Front Caster and Camber Adjustment .

Wheel Alignment Specifications

Fastener Tightening Specifications

Application	Specification
Application	Metric	English
Tie Rod Jam Nut	68 N.m	50 lb ft
Upper/Lower Control Arm Cam Bolt Nuts	190 N.m	140 lb ft

Fastener Tightening Specifications