Home/Hummer/H2/Hummer H2 I (2002-2007)/Repair manual/Communication Devices/Data Link Communication System: Removal & Installation

Contents

Wiring diagrams Section: Communication Devices

Programming

All sections

Data Link Communication System: Removal & Installation Hummer H2 I

Communication Devices

Removal Procedure

Remove the bolts/screws from the data link connector.
Remove the lower data link connector.

Installation Procedure

Place the data link connector into position. NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the bolts/screws to the data link connector. Tighten: Tighten the bolts/screws to 2 N.m (18 lb in).