LUBRICATION SPECIFICATIONS
| Material | Condition | Specification |
|---|---|---|
| Engine Oil (1) | Ambient Temperature From 95°F (35°C) To Over -20°F (-30°C) | SAE 5W-30 |
| Engine Oil (1) | Ambient Temperature Over Than 20°F (-7°C) | SAE 10W-30 |
| Engine Coolant | All | 50/50 Mixture Distilled Water Ethylene Glycol |
| Power Steering Fluid | All | Honda Power Steering Fluid |
| Brake Fluid | All | DOT 3 or DOT 4 |
| Automatic Transmission Fluid | All | DEXRON III |
| ATTS Unit Fluid | All | DEXRON III |
| A/C Refrigerant | All | R-134a |
| A/C Lubricant | All | ND-OIL8 |
| (1) SAE 5W-30 is preferred, use oils displaying the API certification mark with the Starburst Symbol. | ||
| (1) | SAE 5W-30 is preferred, use oils displaying the API certification mark with the Starburst Symbol. |
LUBRICATION SPECIFICATIONS
FLUID CAPACITIES
| Item | Condition | Specification (1) |
|---|---|---|
| Engine Oil | Drained, With Filter | 5.1 Qts. (4.8L) |
| Engine Coolant | Type SH (M/T): Drained | 3.4 Qts. (3.2L) |
| Engine Coolant | Except Type SH (M/T): Drained | 3.5 Qts. (3.3L) |
| Engine Coolant | A/T: Drained | 3.4 Qts. (3.2L) |
| Transmission Fluid | Type SH (M/T): Capacity | 2.3 Qts. (2.2L) |
| Transmission Fluid | Except Type SH (M/T): Capacity | 2.0 Qts. (1.9L) |
| Transmission Fluid | A/T: Capacity | 2.6 Qts. (2.5L) |
| ATTS Unit Fluid | Capacity | 1.0 Qt. (0.95 L) |
| Fuel Tank | Capacity | 15.9 Gal. (60.0L) |
| Windshield Washer Reservoir | All Other | 2.6 Qts. (2.5L) |
| Windshield Washer Reservoir | Canada | 4.8 Qts. (4.5L) |
| (1) Capacities are recommended or calculated levels. Always use dipstick (if available) to measure level. | ||
| (1) | Capacities are recommended or calculated levels. Always use dipstick (if available) to measure level. |
FLUID CAPACITIES
TIRE SPECIFICATIONS
Tire specifications are imprinted on the tire sidewall. The required cold tire inflation pressures are listed on a decal attached to the driver's door latch pillar and must never exceed the maximum value molded on the tire sidewall.
WHEEL SPECIFICATIONS
The original wheel rims on the vehicle comply with all applicable Federal Motor Vehicle Safety Standards. Before replacing original wheel rims, consult a Honda dealer for technical information on wheel specifications.
WHEEL TIGHTENING
Tighten wheel lug nuts to 80 ft. lbs. (110 N.m).
BATTERY SPECIFICATIONS
| CAUTION | When battery is disconnected, vehicles equipped with computers may lose memory data. When battery power is restored, driveability problems may exist on some vehicles. These vehicles may require a relearn procedure. See COMPUTER RELEARN PROCEDURES article in the GENERAL INFORMATION section. |