Contents Section: Sensor Range Charts All sections

Engine Controls - Sensor Operating Range Charts Honda Prelude III рестайлинг

INTRODUCTION

Sensor operating range information is supplied so that it can be determined if a sensor is out of calibration. A sensor that is out of calibration may not set a trouble code, however, it will cause driveability problems.

BARO Pressure - In. HgVolts
02.8-3.0
52.3-2.5
101.8-2.0
151.3-1.5
20.8-1.0
25.3-.5
(1) Measure voltage at appropriate ECU terminals. See WIRING DIAGRAMS .
(1)Measure voltage at appropriate ECU terminals. See WIRING DIAGRAMS .

ATMOSPHERIC PRESSURE (PA) SENSOR VOLTAGE TEST (1)

Temperature - °F (°C)Resistance (Ohms)
4 (-20)15,000-18,000
68 (20)1,000-4,000
176 (80)200-400
(1) Measure resistance across sensor terminals.
(1)Measure resistance across sensor terminals.

COOLANT TEMPERATURE (TW) SENSOR RESISTANCE TEST (1)

Temperature - °F (°C)Resistance (Ohms)
4 (-20)15,000-18,000
68 (20)1,000-4,000
176 (80)200-400
(1) Measure resistance across sensor terminals.
(1)Measure resistance across sensor terminals.

INTAKE AIR TEMPERATURE (TA) SENSOR RESISTANCE TEST (1)

Vacuum Applied - In. Hg.Volts
02.8-3.0
52.3-2.5
101.8-2.0
151.3-1.5
20.8-1.0
25.3-.5
(1) Measure voltage at appropriate ECU terminals. See WIRING DIAGRAMS .
(1)Measure voltage at appropriate ECU terminals. See WIRING DIAGRAMS .

MAP SENSOR VOLTAGE TEST (1)

PositionVolts (Approx.)
Accord & Prelude
Fully Closed1.2
Fully Open4.0
Civic & CRX
Fully Closed1.0
Fully Open4.5
(1) Measure voltage at appropriate ECU terminals. See WIRING DIAGRAMS . Voltage should increase smoothly as vacuum is applied.
(1)Measure voltage at appropriate ECU terminals. See WIRING DIAGRAMS . Voltage should increase smoothly as vacuum is applied.

EGR LIFT SENSOR VOLTAGE TEST (1)

ConditionVolts
LeanLess Than 0.4
RichGreater Than 0.6
(1) Measure voltage between ground and O2 sensor terminal using a high-impedance DVOM.
(1)Measure voltage between ground and O2 sensor terminal using a high-impedance DVOM.

OXYGEN SENSOR VOLTAGE TEST (1)

See also:
WIRING DIAGRAMS