12 Volt Battery: Removal & Installation Honda Pilot II

Battery Removal and Installation

Note. The battery terminal disconnection/reconnection (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ) procedure must be done before and after doing this procedure. Some system store data in memory is lost when the battery disconnected.

Removal

1. Do the battery terminal disconnection procedure (see «BATTERY TERMINAL DISCONNECTION AND RECONNECTION»(ref-333608-S13381695222009072100000) ).
2. Remove the two nuts (A) securing the battery setting plate, then remove the battery setting plate (B) and the battery (C).

Scheme 64

1. Install the battery (A), then install the battery setting plate (B).
2. Tighten the two nuts (C) equally until the battery is stable. NOTE: Do not deform the battery setting plate by tightening the nuts too much.
3. Do the battery terminal reconnection procedure (see «BATTERY TERMINAL DISCONNECTION AND RECONNECTION»(ref-333608-S13381695222009072100000) ).

Note. Make sure the positive terminal and the negative terminal are not reverse-connected.