Home ReviewsRefund
Home/Honda/Fit/Honda Fit I (2004-2009)/Repair manual/Testing & Diagnostics/DTC P0339: CKP Sensor Intermittent Interruption
Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P0339: CKP Sensor Intermittent Interruption Honda Fit I

Testing & Diagnostics ~366 words

Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).

  1. Turn the ignition switch ON (II).
  2. Clear the DTC with the HDS.
  3. Start the engine, and let it idle 10 seconds.
  4. Check the CKP NOISE count in the DATA LIST with the HDS. Are 0 counts indicated? YES - Go to step 7 . NO - Go to step 5 .
  5. Test-drive the vehicle for several minutes in the range of these recorded freeze data parameters: ENGINE SPEED VSS
  6. Check the CKP NOISE count in the DATA LIST with the HDS. Are 0 counts indicated? YES - Go to step 7 . NO - Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the CKP sensor and the ECM/PCM.
  7. Check for poor or loose connections and terminals at these locations: CKP sensor ECM/PCM Engine ground Body ground Are the connections and terminals OK? YES - Go to step 8 . NO - Repair the connectors or terminals, then go to step 11 .
  8. Remove the cam chain case (see «CAM CHAIN REMOVAL»(ref-291404-S37288122382008072800000) ), and check for damage on the CKP sensor pulse plate. Is the pulse plate damaged? YES - Replace the CKP sensor pulse plate (see «CKP PULSE PLATE REPLACEMENT»(ref-291404-S13137132962008072800000) ), then go to step 11 . NO - Go to step 9 .
  9. Turn the ignition switch OFF.
  10. Replace the CKP sensor (see «CKP SENSOR REPLACEMENT»(ref-291411-S11774376892008072800000) ).
  11. Turn the ignition switch ON (II).
  12. Reset the ECM/PCM with the HDS.
  13. Clear the CKP pattern with the HDS.
  14. Do the ECM/PCM idle learn procedure (see «ECM/PCM IDLE LEARN PROCEDURE»(ref-291413-S23447131872008072800000) ).
  15. Do the CKP pattern learn procedure (see «CRANK (CKP) PATTERN CLEAR/CRANK (CKP) PATTERN LEARN»(ref-291410-S23094343812008072800000) ).
  16. Start the engine, and let it idle 10 seconds.
  17. Check for Temporary DTCs or DTCs with the HDS. Is DTC P0339 indicated? YES - Check for poor connections or loose terminals at the CKP sensor and the ECM/PCM, then go to step 1 . NO - Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTCs troubleshooting.

More articles — Pgm-Fi System