Home ReviewsRefund
Home/Honda/Crosstour/Honda Crosstour I (2009-2012)/Repair manual/SRS (Supplemental Restraint System) (4-CYL)/OPDS Sensor Initialization
Contents Wiring diagrams Section: SRS (Supplemental Restraint System) (4-CYL) All sections

OPDS Sensor Initialization Honda Crosstour I

SRS (Supplemental Restraint System) (4-CYL) 1 illustration ~295 words

OPDS Sensor Initialization

When you replace the front passenger's seat-back cover/pad, the SRS unit, and/or the ODS unit, initialize the OPDS sensor with the HDS.

Note. Before initializing the OPDS sensor, clear the DTCs. Before initializing the OPDS sensor, make sure the battery is fully charged. A new (uninitialized) ODS unit installed with a faulty OPDS sensor (DTC 86-1 x or 86-2x) can cause DTCs 85-71 and 85-78. If the SRS has a hard DTC 86-1 x or 86-2x, troubleshoot the DTCs completely before replacing the ODS unit. Make sure all components of the front passenger's seat are correctly installed. Make sure nothing is on the front passenger's seat, including aftermarket seat covers or mats. Make sure there is nothing in the front passenger's seat-back pocket. Dehumidify inside of the vehicle with A/C.

Scheme 562

Scheme 562: OPDS Sensor Initialization
Scheme 562: OPDS Sensor Initialization
  1. Turn the ignition switch to ON (II).
  2. Set the seat-back in a normal position.
  3. Turn the ignition switch to LOCK (0).
  4. Connect the HDS to the data link connector (DLC) (A).
  5. Turn the ignition switch to ON (II).
  6. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, go to the DLC circuit troubleshooting (see «DLC CIRCUIT TROUBLESHOOTING»(ref-512893-S17266721462012110400000) ).
  7. From the HDS Main Menu, select SRS, then INITIALIZATION. In the INITIALIZATION Menu, select ODS Initialization. Follow the prompts until the OPDS sensor initialization has been completed.
  8. Turn the ignition switch to LOCK (0), then wait for 10 seconds.
  9. Disconnect the HDS from the DLC. NOTE: If the ODS unit fails to initialize after several attempts, replace the seat-back cover/pad equipped with an OPDS sensor (see «FRONT SEAT-BACK COVER REPLACEMENT»(ref-512936-S02750348002012110500000) ), and retry. If the ODS unit continues to fail to initialize, replace the ODS unit (see «ODS UNIT REPLACEMENT»(ref-512921-S26376466232012110500000) ).