Home/Honda/Crosstour/Honda Crosstour I (2009-2012)/Repair manual/SRS (Supplemental Restraint System) (4-CYL)/ODS Unit Initialization

Contents

Wiring diagrams Section: SRS (Supplemental Restraint System) (4-CYL)

General Precautions

Airbag Handling and Storage

SRS Unit, Front and Side Impact Sensors, Rear Safing Sensor, Driver's Seat Position Sensor, and Front Passenger's Weight Sensors

SRS Unit Connectors

Waterproof SRS Connectors

Lever-Locked Connector

Disconnecting

Connecting

Spring-Loaded Lock Connector

Front Seats With Side Airbags

Precautions

How to Read DTCs

How to Clear DTCs

SRS Unit Update

ODS Unit Initialization

OPDS Sensor Initialization

Front Passenger's Weight Sensor Initialization

After Replacing Front Passenger's Seat Component(s)

Pre-Operation Check Set-Up

Front Passenger's Weight Sensor Output Check After a Vehicle Collision

Driver's Seat Position Sensor Opera

Airbags

Front Passenger's Weight Sensors

Driver's Seat Position Sensor

Rear Safing Sensor

Front Seat Belt Tensioners

Driver's and Front Passenger's Airbag(s)

Side Airbag(s)

Self-Diagnostic System

SRS indicator does not come on

SRS indicator stays on, but no DTCs are stored, or cannot be read

Side airbag cutoff indicator stays on

Side airbag cutoff indicator does not come on

Passenger's airbag cutoff indicator stays on or comes on suddenly

Faulty seat belt reminder indicator

Checking and Adjusting the Headliner/Pillar Trim Overlap

Airbag and Tensioner Disposal

Deploying Airbags in the Vehicle

Deploying Components Out of the Vehicle

Disposal of Damaged Components

Deployment Tool Check

All sections

ODS Unit Initialization Honda Crosstour I

SRS (Supplemental Restraint System) (4-CYL)

ODS Unit Initialization

Note. After SRS unit or ODS unit is replaced, do this procedure to initialize the ODS unit. ODS unit initialization initializes both the OPDS sensor and the front passenger's seat weight sensor.