Wiring Systems (General Information): Wiring GMC Sierra 2500

Wiring Repairs

The Wiring Repairs section contains the following types of wiring repair information. Using these elements together will make wiring repair faster and easier

1. See «Circuit Protection - Fuses»(ref-175672-S24715877752005042500000) .
2. See «Circuit Protection - Circuit Breakers»(ref-175672-S20907726482005042500000) .
3. See «Circuit Protection - Fusible Links»(ref-175672-S00786874092005042500000) .
4. See «Repairing Damaged Wire Insulation»(ref-175672-S26917170572005042500000) .
5. See «Splicing Copper Wire Using Splice Clips»(ref-175672-S26944465242005042500000) .
6. See «Splicing Copper Wire Using Splice Sleeves»(ref-175672-S02573968642005042500000) .
7. See «Splicing Twisted Or Shielded Cable»(ref-175672-S24814936832005042500000) .
8. See «Splicing In-line Harness Diodes»(ref-175672-S36075839242005042500000) .
9. See «Heated Oxygen Sensor (HO2S) Wiring Repairs»(ref-175672-S06954850552005042500000) .
10. See «SIR/SRS Wiring Repairs»(ref-175672-S09027982912005042500000) .
11. See «Flat Wire Repairs»(ref-175672-S37358064542005042500000) .
12. See «Connector Repairs»(ref-175672-S24507059572005042500000) .

Splicing Copper Wire Using Splice Clips

Important: When making a splice in an area that may be exposed to moisture use a crimp and seal splice sleeve instead of a Splice Clip. Refer to Splicing Copper Wire Using Splice Sleeves .

Splicing In-line Harness Diodes

Many vehicle electrical systems use a diode to isolate circuits and protect the components from voltage spikes. When installing a new diode use the following procedure.

1. Open the harness. If the harness is taped, remove the tape. To avoid wiring insulation damage, use a sewing ripper in order to cut open the harness. If the harness has a black plastic conduit, pull out the diode.
2. If the diode is taped to the harness, remove all of the tape.
3. Check and record the current flow direction and orientation of diode.
4. Remove the inoperative diode from the harness with a suitable soldering tool. Important: If the diode is located next to a connector terminal remove the terminal(s) from the connector to prevent damage from the soldering tool.
5. Carefully strip away a section of insulation next to the old soldered portion of the wire(s). Do not remove any more that is needed to attach the new diode.
6. Check current flow direction of the new diode, being sure to install the diode with correct bias. Reference the appropriate service manual wiring schematic to obtain the correct diode installation position.
7. Attach the new diode to the wire(s) using 60/40 rosin core solder. Before soldering attach some heat sinks (aluminum alligator clips) across the diode wire ends to protect the diode from excessive heat. Follow the manufacturer's instruction for the soldering equipment.
8. Reinstall terminal(s) into the connector body if previously removed. Important: To prevent shorts to ground and water intrusion, completely cover all exposed wire and diode attachment points with tape.
9. Tape the diode to the harness or connector using electrical tape.

SIR/SRS System Wire Splice Repair

Apply a new splice (not sealed) from the J 38125-B if damage occurs to any of the original equipment splices (3 wires or more) in the SIR/SRS wiring harness. Carefully follow the instructions included in the kit for proper splice clip application.