Differentials - Eaton Locking: Removal & Installation GMC Envoy I

REMOVAL & INSTALLATION

See appropriate article in DRIVE AXLES.

Scheme 1

1. Using Governor Remover (J-26252), remove governor bushing. Remove "E" clips holding latching bracket in position on governor shaft. Move latching bracket down shaft.
2. Using governor remover, remove latching bracket bushing. (Scheme 1) Remove latching bracket, shaft and spring from case. Remove governor. Remove lock screw and pinion shaft. Remove pinion gear and thrust washer. Rotate side gear and roll gears out of case.
3. Remove thrust block and right side gear. Remove right clutch plates and side thrust washer. Remove left side gear, cam plate and clutch plates (cam unit) as an assembly. Remove side gear thrust washer.