Wipers and Washers: Removal & Installation Ford Fusion I рестайлинг

REMOVAL AND INSTALLATION

1. Remove the wiper pivot arm cap.
2. Remove the wiper pivot arm retaining nut and the wiper pivot arm. To install, tighten to 20 N.m (15 lb-ft).
3. To install, reverse the removal procedure.

1. Remove the upper cowl panel grille. For additional information, refer to «FRONT END BODY PANELS»(ref-291871) article.
2. Disconnect the windshield wiper motor electrical connector.
3. Remove the 2 windshield wiper mounting arm and pivot shaft assembly bolts and the windshield wiper mounting arm and pivot shaft assembly. To install, tighten to 5 Nm (44 lb-in).
4. To install, reverse the removal procedure.

1. Remove the wiper pivot arms. For additional information, refer to «Wiper Pivot Arm»(ref-291873-S06140787492008073000000) .
2. Remove the windshield wiper mounting arm and pivot shaft. For additional information, refer to «Wiper Mounting Arm and Pivot Shaft»(ref-291873-S14224026312008073000000) .
3. Remove the 2 drive rods from the motor crank arm ball joint.
4. Remove the wiper motor-to-wiper mounting arm bolts and the wiper motor. To install, tighten to 8 Nm (71 lb-in).
5. To install, reverse the removal procedure.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to «JACKING AND LIFTING»(ref-291849) article.
2. Remove the RH front fender splash shield. For additional information, refer to «FRONT END BODY PANELS»(ref-291871) article.
3. Remove the windshield washer pump. Disconnect the electrical connector. Disconnect the hoses. Remove the windshield washer pump.
4. To install, reverse the removal procedure. Fill the windshield washer reservoir with windshield washer fluid.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to «JACKING AND LIFTING»(ref-291849) article.
2. Remove the RH front fender splash shield. For additional information, refer to «FRONT END BODY PANELS»(ref-291871) article.
3. Disconnect the windshield washer pump electrical connector.
4. Disconnect the washer pump hose.
5. Remove the bolt and the windshield washer reservoir filler neck. To install, tighten to 7 N.m (62 lb-in).
6. Remove the windshield washer reservoir fasteners and the windshield washer reservoir. To install, tighten to 7 N.m (62 lb-in).
7. To install, reverse the removal procedure. Fill the windshield washer reservoir with windshield washer fluid.