Engine Ignition - 3.0L (4V): Removal & Installation Ford Fusion I рестайлинг

REMOVAL AND INSTALLATION

RH side

1. Remove the upper intake manifold. For additional information, refer to «ENGINE - 3.0L (4V)»(ref-291910) article.
2. Disconnect the 6 ignition coil-on-plug electrical connectors.
3. Remove the 6 bolts and the 6 ignition coil-on-plugs. To install, tighten to 7 Nm (62 lb-in).
4. To install, reverse the removal procedure. Apply a small amount of dielectric grease to the inside of the ignition coil-on-plug boots before attaching to the spark plugs.

REMOVAL

RH side

1. Remove the upper intake manifold. For additional information, refer to «ENGINE - 3.0L (4V)»(ref-291910) article.
2. Disconnect the 6 ignition coil-on-plug electrical connectors.
3. Remove the 6 bolts and the 6 ignition coil-on-plugs.
4. Remove the 6 spark plugs.

INSTALLATION

Both sides

1. Inspect the 6 spark plugs. For additional information, refer to «ENGINE SYSTEM - GENERAL INFORMATION»(ref-291856) article.
2. Adjust the spark plug gap as necessary.
3. Install the 6 spark plugs. Tighten to 15 Nm (133 lb-in).
4. Install the 6 ignition coil-on-plugs and the 6 bolts. Tighten to 7 Nm (62 lb-in).
5. Connect the 6 ignition coil-on-plug electrical connectors.
6. Install the upper intake manifold. For additional information, refer to «ENGINE - 3.0L (4V)»(ref-291910) article.