GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| High Performance DOT 3 Motor Vehicle Brake Fluid PM-1 (Canada CPM-1) | ESA-M6C25-A or WSS-M6C62-A |
| Silicone Brake Caliper Grease and Dielectric Compound XG-3-A | ESE-M1C171-A |
GENERAL SPECIFICATIONS
FRONT DISC BRAKE SPECIFICATIONS
| Item | Specification |
|---|---|
| Brake Disc | |
| Brake disc diameter | 278 mm (10.94 in) |
| Brake disc nominal thickness (new) | 25 mm (0.98 in) |
| Brake disc minimum thickness | 23 mm (0.91 in) |
| Brake disc minimum thickness to machine | 23.5 mm (0.93 in) |
| Maximum brake disc runout (installed) | 0.050 mm (0.002 in) |
| Maximum brake disc thickness variation | 0.020 mm (0.0008 in) |
| Brake Pads | |
| Brake pad minimum thickness | 3.0 mm (0.118 in) |
| Brake pad maximum thickness variation (pad-to-pad) | 2.0 mm (0.079 in) |
| Brake pad maximum taper wear (in any direction) | 3.0 mm (0.118 in) |
FRONT DISC BRAKE SPECIFICATIONS
TORQUE SPECIFICATIONS
| Description | Nm |
|---|---|
| Brake caliper anchor plate bolts | 133 |
| Brake caliper bolts | 28 |
| Brake caliper hose fitting | 15 |
TORQUE SPECIFICATIONS
The front disc brake system consists of the following components
- Caliper
- Dust seal
- Piston
- Piston seal
- Caliper bleeder screw
- Brake pads
- Anchor plate
- Rotor
- Dust shield
The front disc brake system consists of a single-piston front disc brake caliper and a ventilated front disc brake rotor. The brake pads are held in the front disc brake caliper by 2 front disc brake caliper bolts.
To remove the brake disc shield you must remove the wheel knuckle. Refer to FRONT SUSPENSION .
Refer to BRAKE SYSTEM-GENERAL INFORMATION .
See also:
• JACKING AND LIFTING