REMOVAL AND INSTALLATION
| WARNING | When carrying out underhood work in the vicinity of the starter motor, be aware that the heavy gauge battery input lead at the starter solenoid is "electrically hot" at all times. A protective cap or boot is provided over the terminal of this lead and must be reinstalled after servicing. |
| WARNING | When working in the area of the starter motor, be careful to avoid touching hot exhaust components. |
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to «JACKING AND LIFTING»(ref-278237) article.
- Disconnect the battery ground cable. For additional information, refer to «BATTERY, MOUNTING AND CABLES»(ref-278287) article.
- Remove the starter solenoid wire nut. To install, tighten to 5 Nm (44 lb-in).
- Remove the starter solenoid battery cable nut and disconnect the wiring. To install, tighten to 12 Nm (9 lb-ft).
- Remove the power steering tube bracket nut and position the power steering tube and bracket aside. To install, tighten to 20 Nm (15 lb-ft).
- Remove the upper bolt, the lower stud bolt and the starter motor. To install, first install the upper bolt and lower stud bolt finger tight. Tighten the upper bolt to 35 Nm (26 lb-ft). Tighten the lower stud bolt to 35 Nm (26 lb-ft).
- To install, reverse the removal procedure.