Engine Mechanical - 3.5L Gtdi: Overhaul Ford Flex I

Disassembly

Note. If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations.

1. Using the Valve Spring Compressors, remove the keys, retainer and spring.
2. Remove the valve from the cylinder head.
3. Remove and discard the valve stem seal.
4. Repeat the above steps for each valve.
5. Remove the turbocharger oil supply quick connect fitting. Inspect and if necessary, replace the quick connect fitting.
6. If equipped, remove and discard the Cylinder Head Temperature (CHT) sensor.

Scheme 522

1. NOTE: Lubricate the valve stem seal with clean engine oil prior to installation. Using the Valve Stem Oil Seal Installer, install a new valve stem seal.
2. Install the valve.
3. Using the Valve Spring Compressors, install the valve spring, retainer and key.
4. Repeat the above steps for each valve.
5. Install the turbocharger oil supply quick connect fitting. Tighten to 16 Nm (142 lb-in).
6. If equipped, install a new CHT sensor. Tighten to 10 Nm (89 lb-in).