Home/Ford/Fiesta/Ford Fiesta Mk6 (2011-2013)/Repair manual/Mirrors/Rear View Mirror: Removal & Installation
Contents Wiring diagrams Section: Mirrors All sections

Rear View Mirror: Removal & Installation Ford Fiesta Mk6

Mirrors 1 illustration ~278 words

Removal and Installation

  1. Remove the door trim panel. For additional information, refer to «INTERIOR TRIM AND ORNAMENTATION»(ref-382432).
  2. see scheme 23 Items in the exploded views may not be listed in order of removal. NOTE: In order to ensure the most accurate information, some procedural and pinpoint test steps may be under development and not immediately available at vehicle introduction.
  1. WARNING: Place a shop towel between the hands and the exterior mirror glass for protection in case of glass breakage during mirror service. Failure to follow this instruction may result in serious personal injury. see scheme 23 Items in the exploded views may not be listed in order of removal. NOTE: In order to ensure the most accurate information, some procedural and pinpoint test steps may be under development and not immediately available at vehicle introduction.
  1. see scheme 23 Items in the exploded views may not be listed in order of removal. NOTE: In order to ensure the most accurate information, some procedural and pinpoint test steps may be under development and not immediately available at vehicle introduction.
  1. see scheme 23 Items in the exploded views may not be listed in order of removal. NOTE: In order to ensure the most accurate information, some procedural and pinpoint test steps may be under development and not immediately available at vehicle introduction.

Scheme 23

Scheme 23: Exterior Mirror Control Switch
ItemPart NumberDescription
117B676Exterior mirror control switch
2Exterior mirror control switch electrical connector (part of 14631)

ITEMS DESCRIPTION CHART

  1. NOTE: Make sure to use a non-marring tool when removing the exterior mirror switch. Otherwise, damage to the door trim panel may occur. Remove the exterior mirror control switch. Insert a non-marring tool between the door trim panel and the exterior mirror control switch and gently pry outward.