Installation
Note. Install only a V-lock design block heater.
- Clean the engine block mating surface with metal surface prep. Follow the directions on the packaging.
- Position the block heater and finger-tighten the nut, making sure the block heater electrical connector points to the 8 o'clock position.
- Tighten the block heater nut. Tighten to 3 Nm (27 lb-in).
- Connect the electrical connector.
- Fill and bleed the cooling system. For additional information, refer to «COOLING SYSTEM DRAINING, FILLING AND BLEEDING»(ref-382413-S08846205852011012300000) in this information.
Scheme 2
| Item | Part Number | Description |
|---|---|---|
| 1 | W520412 | A/C tube bracket nut |
| 2 | 19D626 | A/C tube bracket |
| 3 | 8100 | Pressure relief cap |
| 4 | W527311 | Degas bottle-to-engine hose clamp |
| 5 | 8K276 | Degas bottle-to-engine hose |
| 6 | 8B081 | Engine-to-degas bottle hose |
| 7 | 8A080 | Degas bottle |
ITEM DESCRIPTION CHART
- see scheme 11 Items in the exploded views may not be listed in order of removal. NOTE: In order to ensure the most accurate information, some procedural and pinpoint test steps may be under development and not immediately available at vehicle introduction.